Have a look at
http://www.zerobeat.net/mediawiki/index.php/K3_Firmware_Error_codes#ERR_TXGAnd see if that helps.
If not, I'm afraid I don't know, but mail <
[hidden email]>, they
should be able to help.
When you get it resolved, please drop me a mail (off list if you wish) with
the solution.
73 de M0XDF, K3 # 174, HexKey # 375
On 16/1/08 22:46, "Geoff Cottrell G3XGC" <
[hidden email]> sent:
> I am getting this Err TXG message (transmit gain constant out of range)
> when trying to set up my newly installed KPA3 at the 50W level. Had no
> problems at 5W level 160m-6m gives 5W out as per manual. The K3 working
> fine at the LP level. But at 50W power setting level cannot get more
> than 9W out and get the Err TXG on all these bands. Tried EE init
> followed by restore parameters using K3 Utility prog. No change.
> When installing the KPA3, and testing the KPAIO3 interface as on p. 14
> of the installation instructions, I did not hear a relay click when
> moving between NOR and TST. Cycling the power button made no change.
> I am stuck - what should I do next?
>
> Thanks for any help.
> Geoff G3XGC
> K3 SN 225
--
Don't say you don't have enough time. You have exactly the same number of
hours per day that were given to Helen Keller, Pasteur, Michaelangelo,
Mother Teresa, Leonardo da Vinci, Thomas Jefferson, and Albert Einstein.
-H. Jackson Brown, Jr., writer
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
