???? No text except title?
I have the same issue on my KX3-2m: "Hi-Current" blinking even on dummy
load but 3 W output still available . Having a loose SMA connector , I
had to open KX3 and extract 2m card in order to tighten SMA nut (very
annoying!) . I found it was convenient to use a short piece of coax
cable with SMA male connector and N female (or what you want) at the
other end in order to avoid stress on SMA female on KX3 .
KX3-2M is very sensitive but a lot of birdies presents so this is not
very compatible with weak signals reception, even using transverters in
front adding noise masking the weakest ones compared to my IC-7400 and
other transceivers . My DB6NT microwave transverters are well driven
into TX using + TX available on SMA inner conductor; very good point!
Another issue I have is a sort of "microphone effect" in RX ; not sure
this is the right words ?
Any help?
73's.
Jacques F6AJW/IN93EK
Le 01/08/2015 15:18, John Sager via Elecraft a écrit :
---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
