Hmmmm Help .... Micro KEYER II & K3S

[Paul Van Dyke]

I have shiny K3s, and a nice shiny MicroHAM Micro KEYER II. and the cable
they sent when they said what radio (K3 series) and "guessing" I am NOT the
only one with a K3s .... How did you interface it?? As what did you connect
up as all the paperwork is strictly for the K3. Looking for a bit of
assistance as I am a bit frustrated as I do have messages to Microham and
their forum and no answer back..

Do you have any ideas

Paul  KB9AVO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Joe Subich, W4TV-4]

microKEYER II interfaces to both the K3 and the K3S the same way.

With the K3S one uses the Elecraft supplied E98027 cable between the
RS232/P3 (RJ-45) jack and the XCVR jack of the P3 *as shown on page*
*19 of the K3S Owners Manual*.  The RS-232 plug from the DB37-EL-K3R
or DB37-EL-K23 cable connects to the PC jack of the P3.  If you do
not have the P3, connect the RS-232 plug from the microHAM cable to
the DE9 connector of the Elecraft supplied E98027 cable.

*DO NOT USE* the Elecraft CBLP3Y cable and USB connection on the K3S.

The +13.8V (power) plug connects to the "switched 12V" output of the
K3/K3S (and the DB37PWR jumper in MK II is set to power from the cable
instead of the +13V jack - per the microHAM Users Manual).  Line
In/Line Out, ACC, PTT, Mic and Key plugs attach to the matching jacks
on the K3/K3S.  Note: the K3S should be configured for RS-232 and
*not* USB as documented in the Elecraft K3S Owners Manual.

73,

    ... Joe, W4TV


On 2/17/2017 8:43 PM, Paul Van Dyke wrote:

> I have shiny K3s, and a nice shiny MicroHAM Micro KEYER II. and the cable
> they sent when they said what radio (K3 series) and "guessing" I am NOT the
> only one with a K3s .... How did you interface it?? As what did you connect
> up as all the paperwork is strictly for the K3. Looking for a bit of
> assistance as I am a bit frustrated as I do have messages to Microham and
> their forum and no answer back..
>
> Do you have any ideas
>
> Paul  KB9AVO
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [hidden email]
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]