Don't know about an iMac, I have studiously avoided anything whose name
begins with a lower case "i", but ...
I run W7RN remotely with my K3 and the RRC 1258Mk2 and use N1MM in
contests on a PC. Here's my recipe:
1. Serial cable from control K3 to back of RRC box. This establishes
remote control.
2. USB from RRC front panel connector to PC. When connected, the RRC
box creates 4 virtual COM ports -- COM0, COM1, COM2, and COMExtra. In
device mgr, they will have a "real" COM port assigned in parentheses.
3. Locate the virtual port COM1, and note the "real" port in parens.
That's the port # that goes into N1MM.
The frequency data comes from the remote K3, not my local control K3.
So, if you can translate that into Apple-ese, it should work for you.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the Cal QSO Party 1-2 Oct 2016
- www.cqp.org
On 5/3/2016 5:12 AM, VK5CP wrote:
> Hi,
>
> I have a K3/0 and K3 remote station setup using the most recent
> hardware/firmware version of Remoterig RRC-1258MkII connected via the mobile
> phone network.
>
> At the K3/0 end I use a IMac computer with MacloggerDX - I would like to
> connect the K3/0 via USB to the Imac to automatically feed in the freq/mode
> data? I have tried but it does not seem to work.
>
> Has anyone worked this out at their station?
>
> Regards
>
> Chris VK5CP
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
