IF display while xmitting

[alsopb]

I use an SDR here connected to the K3 IF.

SKIMMER or ROCKY run off this SDR.

When I transmit the my displayed xmit signal appears 800 Hz above the
station I'm zero beat with.  This is regardless if normal or REV CW is used.

My pitch is set to 500 Hz.  The station being received is producing this
pitch.

I don't understand this at all.

The "IF frequency" in the SDR's must be set right.  Clicking on a spot
puts me right on that stations frequency.

73 de Brian/K3KO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[KK7P]

  The K3 Tx IF is not necessarily the same as the Rx IF. Possibly
dIfferent roofing filter, possibley different offset, and differrent
strategy/algorithm used.

73,

Lyle KK7P

> When I transmit the my displayed xmit signal appears 800 Hz above the
> station I'm zero beat with.  This is regardless if normal or REV CW is used.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html