IF-out from sub-rcvr?

[Ken AK1Q]

Hi,

Is there a way to have the IF-out from the KVX-3 be from the sub-receiver?
 

My K-3 is on order and I have been reading the K-3 manual carefully but
have seen nothing on this.  The block diagram makes me doubt this is
possible, but I thought I'd ask.

Thanks,
Ken
AK1Q


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Bruce Beford-2]

Hi Kenneth.

Congratulations on the impending arrival of your K3.

The KXV3 (or, in your case 3A, as this is a new order) does NOT have the
connections available to output an IF signal from the subreceiver (as far as
I know). However, some users have modified the KRX3 by adding a small buffer
amp inside, and routing this signal out to a user-supplied rear panel jack
for just this purpose.

So, It CAN be done, but it is an exercise left to the user (at this time).

73,
Bruce N1RX
K3 s/n 559
 


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html