We have just uploaded an important mod to the K3 Mod and App notes page.
This mod adds one wire to the K3 FP board to correct a problem with VOX
operation and low mic gain when Electret mics requiring mic bias on the
mic audio line were used on the front panel connector of the K3.
(Recently reported on the Elecraft reflector.)
See:
http://www.elecraft.com/K3/k3_app_notes.htm
Symptom:
Incorrect K3 VOX operation (VOX 'hangs') and/or low or corrupted TX
audio, when using a front panel mic which requires BIAS to be supplied
to the mic through the audio pin. (Elecraft MH2, MD2, Proset-K2 with
electret elements etc.)
Rear panel mic connections do not exhibit this problem. Dynamic-style
microphones (mics which do not require a bias voltage on the mic audio
pin) do not demonstrate this problem.
Applicability:
K3s with serial numbers between 660 and 782 with Rev B Front Panel PC
boards. (K3s as early as S/N 654 may demonstrate this problem, but we
think the problem starts with S/N 660.)
Other K3s DO NOT require this mod. All K3's that are currently shipping
have this corrected. All K3s from s/n 783 on have this corrected.
If you have an electret microphone which is wired for the K3 (Elecraft
MH2, MD2, Proset-K2 etc) you can test for presence of this problem by
attaching the mic to the front panel mic connector, setting "MENU | MIC
fpL bias" or "MENU | MIC fpH bias" and seeing if the symptom above is
present.
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
