I drilled the middle holes out large enough to take a nut, then used epoxy resin
to glue the nut into the heatsink. Works a treat.
73
Stewart G3RXQ
On Fri, 26 May 2006 17:46:43 -0400, Roy Morris wrote:
> I do not think the ovrsized screws are the answer for the K2/100. Over time
> I don't believe they will remain tight if you go into the K2 enough times and
> might even strip. For this reason I have never put a screw in that hole. I
> am thinking of drilling a hole at the precise right place in the first
> cooling fin, tapping the hole and putting in a long enough screw that will
> hold. I don't think the screw would be noticable if it is the same color as
> the other screws. What do some of you think about this? Roy Morris W4WFB
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
