Hey Tony.thanks for the tip. Sure enough, the #2 synth board was one whole
row of pins closer to the front than it should have been. When aligned in
the socket properly, it works perfectly. Glad I got this working. it's
going to J68 for 2 weeks in August. Much better than that problematic Flex
3000 I took to PJ4 two months ago. It's up for sale.
Dr. William J. Schmidt - K9HZ / J68HZ/ 8P6HK/ ZF2HZ/ PJ4HZ
Owner - Operator - K9ZC
Big Signal Ranch
Staunton, Illinois
email:
[hidden email]
From: Anthony Scandurra [mailto:
[hidden email]]
Sent: Saturday, July 14, 2012 7:43 PM
To:
[hidden email]
Subject: Re: [Elecraft] Just finished building
Same thing happened to me.
My synthesizer board was plugged in offset by one pin.
It's an easy to make error.
Double check your board positioning.
Good luck!
73, Tony
On Jul 14, 2012 6:52 PM, "Dr. William J. Schmidt, II" <
[hidden email]>
wrote:
I just finished building my new K3. has sub receiver and when I tried to
calibrate the sub-Synthesizer I get an error:
E00005 ERR VCO
E00255 ERR VC4
Any ideas?
Dr. William J. Schmidt - K9HZ / J68HZ/ 8P6HK/ ZF2HZ/ PJ4HZ
Owner - Operator
Big Signal Ranch
Staunton, Illinois
email: <mailto:
[hidden email]>
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html _____
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2437/5132 - Release Date: 07/14/12
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
