K-3 KPA3 Help

[Howard Stephenson - K6IA]

I'm in the final stages of my K-3 build.
When I went to install the KPA3 I noticed a pin missing on connector
P68A which plugs into the KPAIO3 board. It appears to be cut off
flush.
Is this normal?
Thanks
Howard Stephenson K6IA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Iain MacDonnell - N6ML-2]

On Fri, Nov 25, 2011 at 6:30 PM, Howard Stephenson
<[hidden email]> wrote:
> I'm in the final stages of my K-3 build.
> When I went to install the KPA3 I noticed a pin missing on connector
> P68A which plugs into the KPAIO3 board. It appears to be cut off
> flush.
> Is this normal?

Is the corresponding hole on J68A on the KPAIO3 board plugged? It may
be keyed so that you can't plug the KPAIO3 in backwards. According to
the schematics, pins 5 and 6 on J68A/P68A are not used.

73,

    ~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html