Great suggestion Tony, and quick. I knew that the K3S's had the same
firmware revision as I did them at the same time months ago however this
evening I checked the K-PODs and the original one was out of date. It was
easy to update and now both act the same with the D4 LED being on all the
time. At least this explains why they acted differently. Neither radios will
switch the light using the KPLED4 command, perhaps a radio firmware update
would help however at the moment I have no interest in using the LED in a
macro so I'll leave it alone.
73,
John KK9A
Tony G6GLP wrote:
Wed Jan 3 07:39:59 EST 2018
Hi John,
I would check the s/w versions of each of the rigs and kpods to make
sure they are all the same.
try exchanging one kpod with the other and see if the led on stays with
the rig or the kpod.
My guess is the sw in one of the devices is lower than the other device.
73 de Tony G6GLP
On 03/01/2018 12:23, john at kk9a.com wrote:
> I purchased another K-POD and on New Years day I connected it to my second
> K3S. I programmed it identically to my first one. Both appear to work the
> same except the new one has the LED 4 on and on the original the LED is
> off. None of my programs were written to control LED 4. To make them the
> same, in the Elecraft utility, I tried KPLED4ON; and KPLED4OFF; with each
> unit and it had no effect so I still have one K-POD with the LED 4 on and
> one with LED 4 off. I tried typing this command in the test area and also
> I created a temporary macro button and neither had any effect. How can I
> turn this light on or off?
>
> John KK9A
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
