I was recently at the transmitter alignment stage, and apparently did not fully understand the procedure. I did not exit the "TUNE" mode, but kept tweeking the pots for max power. I melted the grommet, but was getting 6+ watts out up until that time.
Elecraft graciously sent me a new Q7, which I was hoping was the only thing I damaged. I now do not get any power out when attempting the alignment procedure. Maybe I damaged other components?
I do not, or have not built an RF probe, and am kind of new to this electronic testing.
Does anyone have some suggestions so I can again see poer out? Kind of sitting here stumped at the moment and would appreciate any suggestions to get me moving along.
Thanks, Steve
KB7PEF
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
