K1 FRONT PANEL BOARD

[Steve Howard]

On page 21 of the K1 manual it says to check the adjacent pads on U1
Does that mean checking across ?
for ex pin 1 to pin 40 , pin 2 to pin 39 etc or does that mean
pin 1 to pin 2, then pin 2 to pin 3 etc
thanks,

Steve
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

Steve,

You are mainly checking for solder bridges in that test, and a solder
bridge in much more likely between pins 1 and 2 than it is between 1 and 40.

73,
Don W3FPR

Steve Howard wrote:
> On page 21 of the K1 manual it says to check the adjacent pads on U1
> Does that mean checking across ?
> for ex pin 1 to pin 40 , pin 2 to pin 39 etc or does that mean
> pin 1 to pin 2, then pin 2 to pin 3 etc
> thanks,
>
> Steve
>  
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html