I have just completed the front panel board on my K1 up to the resistence check portion. Everything seems to have gone in fine, except the resistance checks aren't matching up.
Checks are from ground to all pin of the LCD and front ground to the jumper pins 6,7,8,10,12,15,16, and 19. Except for Jumper pins 10,15, and 16, these should all read a resistance of >100k. Jumper pins 10, 15, and 16 all read within the specified ranges. All the pins that are supposed to read >100k read approximately 40k.
These measurements are all taken with a DMM. Any ideas?
Randall H. Sanborn
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
