Don, I greatly appreciate your help and suggestions. I carefully
checked everything you mentioned (using an ohmmeter), and I cannot find any
problems.
However, I think I found the problem ! I cannot read the numbers on FP Q1,
until tomorrow when I pull the front panel off. However! I apparently
could not find a 2N4124 at that point, and foolishly concluded that a
substitution had been made with a “4424". So what I believe I installed at
Q1 is the ZN4424. At least, I made a note to that effect. I will take it
apart and check tomorrow.
Now I don’t know what I installed at Q4, so will pull that apart tomorrow
also, after I confirm that the wrong device is on FP Q1. Your help led me
to the problem... I greatly appreciate it. David AC4BN
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
