My K1 VFO has stopped tuning.
The rig was (pretty much) fine till I replaced the tuning pot (plastic for
metal), but the problem doesn't seem to be there. I measure approx 0 to 100
k resistance as far as pin 1 of RF-RP2, so the new pot appears to be doing
its job. Voltage measured at D3 (5.9V) changes less than 0.1 V thru the
entire 100k tuning range, however, which I don't think is right.
Other info: RIT works. VFO OSC = 3.086. I can hear WWV at 10 MHz. E42 occurs
with pot at 100k.
Can anyone tell me if this points to a particular culprit? I'm continuing
troubleshooting, but time at the bench is at a premium and I'm hoping to
find a shortcut to the solution.
Scott N1AIA
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
