Rather than sacrifice the AGC control, I handled the on/off of the K1
backlight by adding an internal on/off switch. I used a very small
Elecraft DPDT switch left over from the K1 Upgrade Kit I installed
awhile back (I didn't need the ability to turn the tx mixer on during
receive, so the switch was unused).
Looking at the the front panel's rear (where the MCU is located) I
installed it on the upper right corner of the PC board. The switch is so
small it is held in place with a tiny drop of medium thick CA glue. See
picture at:
http://home.earthlink.net/~windependent/images/switch.jpgI drilled two very small holes through the PC board with a pin vise and
wired the switch in series with the anode of the backlight diode using
kynar coated wire.
I leave the light on all the time when at home in the shack (95% of my
operating). When portable or if current drain is an issue, all i need to
do is back out the 4 screws holding the front panel in place and flip
the switch.
Mike, AK3F
K1 #522
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
