Karl
My choice was 40/30/20/15 for the four band board, plus a two band board
with 80/40 for the winter months. Beware, calibration will need to be
re-done when changing boards if you have 40m available on both boards
due to crystal tolerances between the boards. An old tip from another
poster to the reflector is to put a rubber band through each of the
stand off spacers to hold them in place on the long bolts while changing
band boards (applies to a K1 with ATU).
73 Dave, G4AON
K1 #1154
----------------------------
A brand new K1 is awaiting my soldering iron.
For the past week I've been agonizing over band selection
15 meters or 17 meters?
What's yer guess folks? Which band will be best when the sunspots return?
Carl
WA7CS
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
