K1 filter boards

[K1DWZ]

I have a K1 which I purchased all built.  It has the 40 and 20 mtr filter
board in it. I purchased and built the ATU and noise blanker.  I haven't used my
other HF rigs since I started using this radio.   Now I wish I had more bands
to operate on with it.  Does anyone have a four band filter board for
40.30,20,15 mtr that has been assembled,aligned and calibrated that is in  excess to
their needs and would like to sell it ?  Or maybe a two band board for 30 and
15. Contact me off list.
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Andrew Moore-4]

I have an application that involves remotely locating the K2's shaft
encoder (Z1) and liquid crystal display components (the backlit LEDs D2
and D3, and the 8 digit LCD, DS1).  The extension length is roughly 10
or 15 feet.  Are the signals likely to degrade much?  I'd plan on using
shielded wires for each signal (though maybe not necessary on low
frequency onces such as LED power).  Coax?  Shielded twisted pair?  What
might be best?

--Andrew
NV1B


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Andrew Moore-4]

I should be more clear -- the rig (including front panel board, control
board, RF board) stays in one location; the LCD and encoder (and a few
pushbuttons) are 10 to 15 feet away (i.e. not even soldered to the PC
board).

--Andrew

> I have an application that involves remotely locating the K2's shaft
> encoder (Z1) and liquid crystal display components (the backlit LEDs D2
> and D3, and the 8 digit LCD, DS1).  The extension length is roughly 10
> or 15 feet.  Are the signals likely to degrade much?  I'd plan on using
> shielded wires for each signal (though maybe not necessary on low
> frequency ones such as LED power).  Coax?  Shielded twisted pair?  What
> might be best?


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com