Hi everyone,
I'm trying to improve the frequency stability of my K1, but I'm not
sure if I'm sort of at the limit here or not. I'm evaluating the
radio's capabilities for use as a 10-meter beacon, and have been
running it into a dummy load for a while, controlled by an external
PIC based controller.
I've rewound L1 to move the tuning range up to where I want it, and
replaced C2 to give me just a narrow tuning range. I'm using an NP0
capacitor for C2 so it should have good temperature stability.
What I've found is that the frequency seems to drift upwards over the
course of 2 or 3 days, going up 100 or so Hz.
The other strange thing I found was that the power out also drifted
upwards. I had the radio set for 2.0 watts and after a day, it was
running 4.5 watts out, which is as high as it goes on 10 meters. The
power out isn't my main concern right now though, 4.5 watts will be
fine.
I know the specs say < 200 Hz / hour but I'm really hoping to see
less than 100 Hz per month, kind of thing. Is there any way to
tighten-up the frequency stability even further?
Thanks and 73 de
Stephanie va3uxb
K2#5311 - K1#2132
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
