Hi David,
The K144XV is compatible with both the low and high power versions of
the K3. Previously manufactured units may require updates in certain
sheet metal so be sure and tell the factory the version of the K3 that
you have or that you upgrade to.
73,
Bob, N6CM
On Sun, Jul 5, 2009 at 1:09 PM, David Feldman<
[hidden email]> wrote:
> If a K144XV is purchased for a basic (10W) K3, then later a KPA3 is added,
> does the K144XV module need to be replaced or can it be re-used?
>
>
>
> An entry (copied below) from www.elecraft.com/elecraft_prod_list.htm#k3 says
> there are two ways to order K144XV, but an e-mail to elecraft asking how I'd
> handle this sequence went unanswered.
>
>
>
> "IMPORTANT: Check one: For a K3/10 For a K3/100"
>
>
>
> Thanks,
>
>
>
> 73 Dave WB0GAZ
>
>
>
>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
