K160RX

[ghaffly]

Group , I am suppose to align the 160 module using CAL PLL.
I have the band on 160 with the VFO at 1800.1.
Using CAL PLL at TP1 I get the INFO 232 message that CALL PLL should be done
on 40 meters.
Need help.

Glenn
K5ZE

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[n6wg]

Glen
Look for an errata sheet for the K160RX.
Turns out that the CAL PLL is done on 40m only these days.
Good luck and 73
Bob N6WG

----- Original Message -----
From: "Glenn Haffly" <[hidden email]>
To: <[hidden email]>
Sent: Sunday, February 10, 2008 9:19 AM
Subject: [Elecraft] K160RX


> Group , I am suppose to align the 160 module using CAL PLL.
> I have the band on 160 with the VFO at 1800.1.
> Using CAL PLL at TP1 I get the INFO 232 message that CALL PLL should
be done

> on 40 meters.
> Need help.
>
> Glenn
> K5ZE
>
> _______________________________________________
> Elecraft mailing list
> Post to: [hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Jukka Tarvainen-2]

>
> Group , I am suppose to align the 160 module using CAL PLL.
> I have the band on 160 with the VFO at 1800.1.
> Using CAL PLL at TP1 I get the INFO 232 message that CALL PLL
> should be done
> on 40 meters.
> Need help.
>
> Glenn
> K5ZE
>

Hi Glenn!

K160RX manual rev D states:

"The following step is only necessary if your K2 firmware is older than
revision 2.00. With
revision 2.00 and up, CAL PLL is done only once (on 40 m), so there's no
need to do it on 160 m."

73 de Jukka OH4MFA
K2/100 #4293

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com