Some differences found during my recent building.
Manual is RevC, Feb 2004 with Errata Rev C-5 July 20 2005
P14
Clearance under Heatsink RHS column first item. On my heatsink there was a
land in the area of C65, C75 and C74 which reduced the board to heatsink
clearance to 4.0mm. The stated clearance needed is "4.5mm"
P31 fig 23 and fig 22
The shown position of the earth wire from J2 obstructs the earthing clip now
part of the additional shield earthing.
P48
RHS column item 6. The holes in the spring clips were too small for the
supplied screws and I needed to enlarge the holes slightly.
P49 fig 39
The RHS of the end elevation below does not align with the plan view above.
P64,65
The circuit diagram is extremely hard to read because the interconnection
"dots" are way too small. A lot less than other Elecraft circuits.
Hope this assists
73, Nigel ZL2DF
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
