K2/100 Power on no RX or PA?

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

K2/100 Power on no RX or PA?

Gene N4FZ
This has been an intermittent problem. When the rig sits for a week or so, Upon powering ON, the RX is muted, the menu setting shows PA _ _ _, and it will not transmit but shows a HI REFL message. I have it connected to both a dummy load and a known good HF antenna. In the MENU, I can not adjust the PA to come ON again. Powering the rig ON/OFF 5 or more times will solve the issue. What could be causing this? Thanks Gene
Reply | Threaded
Open this post in threaded view
|

Re: K2/100 Power on no RX or PA?

Don Wilhelm
Gene,

Intermittent problems are usually caused by a bad connection somewhere.
If it is in a connector, usually removing the connector and replacing it
will wipe away any oxidation interfering with proper contact.

In this case it appears that the MCU is not sensing the KPA100.

I would suggest that you first re-seat the KPA100 ribbon cable (both
ends) and the KPA100 firmware IC.

If that does not correct it, re-seat the MCU - Control Board U6.

While you have the shield off the KPA100, check the diodes D16 and D17
to see if they test as good diodes.  They normally show very high
reverse resistance and near 430 ohms forward resistance.
An alternate quick check on the health of the diodes is to measure the
resistance to ground from pin 3 and pin 5 of KPA100 U5.  If normal it
will be about 43k.

73,
Don W3FPR


On 3/26/2017 9:47 AM, Gene N4FZ wrote:
> This has been an intermittent problem. When the rig sits for a week or so,
> Upon powering ON, the RX is muted, the menu setting shows PA _ _ _, and it
> will not transmit but shows a HI REFL message. I have it connected to both a
> dummy load and a known good HF antenna. In the MENU, I can not adjust the PA
> to come ON again. Powering the rig ON/OFF 5 or more times will solve the
> issue. What could be causing this? Thanks Gene
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]