K2 #4948 snag

[kc5wa]

On page 26 right coluum last instruction reads
"Place two 3/4" (19mm) spacers over the leads
of each back light  LED as shown in Figure 5-9"
-------------------------------------------------
Now to the best of my knowledge NO SPACERS
such as those described fig 5-9 were in the parts list.
Unless it is the two 8mm x 8mm square black pads.
and these need two be split in half and stacked to get
the required 1/8 spacing on the diffuser. Thanks for
any help...
de "rc" kc5wa


--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.4.0 - Release Date: 6/1/2005

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Mike Markowski]

 "RC" KC5WA wrote on 06/01/05 09:50 ET:

> On page 26 right coluum last instruction reads
> "Place two 3/4" (19mm) spacers over the leads
> of each back light  LED as shown in Figure 5-9"
> -------------------------------------------------
> Now to the best of my knowledge NO SPACERS
> such as those described fig 5-9 were in the parts list.
> Unless it is the two 8mm x 8mm square black pads.
> and these need two be split in half and stacked to get
> the required 1/8 spacing on the diffuser. Thanks for
> any help...

RC,

The spacers are the little pieces you previously will have snapped off
of the switch spacing tool.

73,
Mike  AB3AP
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com