I just finished Alignment and Test, Part I... Will begin Assembly, Part
II. Maybe tonight after the Baseball game.
First a couple of points. It was on this reflector about how to install
the Tilt Bail and until I remember it I really struggled with it. Using
4 very long (1.5") 4-40 screws I loosely attached the bail. After
tightening them and aligning the bail and feet I replaced each screw
with the recommended length screw, nut and lock washer. During the Part
I, tests I noticed that LED BAR GRAPH segment 2 & 3 didn't light up I'm
thinking a badly soldered pair of pins AND on the LCD display the
Segment above the letter "A" part of the segment doesn't lite "B's" look
like "E's" again I'm thinking of solder connections. At present I don't
want to unassemble #4948 to look for them with additional information.
OBTW I did build the RF PROBE, FREQ COUNTER PROBE & VOLT METER PROBES
to use the on board systems
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.4.1 - Release Date: 6/2/2005
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
