Hallelujah! K2 #5945 is finished and has power on all bands. Woohoo! :)
It's a little low on 10M (like 8 or 9W total). Not sure if that's
something to worry about or not.
Anyhow, I'm just starting to build the KPA100. I have not yet put all
the covers on the K2, nor the speaker, etc. From what I can tell, none
of that needs to be done as the KPA100 comes with that (and replaces
that).
So, at the end of the section where the final TX alignment is done, is
it alright to go ahead and begin installation of the KPA100 at that
point?
Also, I figure the K2 could use a full alignment, start to finish. Is
there a guide somewhere that does all the calibrations, alignments,
etc. ?
Thanks for all the help, you've been very helpful.
-Jeff
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
