Allan,
Carve away a bit of the plastic on the socket near pin 1 - cut away
enough to get the soldering iron tip in contact with the pin (yes, it
may also melt a bit more of the plastic and raise a stench). The feed
the solder onto the solder side - under the LCD. It takes a bit of
patience, but is much easier and better than attempting to de-solder the
LCD.
73,
Don W3FPR
Allan Glasdam wrote:
> I have an error on FP in U1 pin 1, which is not soldered.
> LCD is in place and soldered. How do I manage to solder pin 1 ?? Any
> suggestions are welcome.
>
> 73 Allan
> OZ8A - 5Q8A
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG -
http://www.avg.com
> Version: 8.0.175 / Virus Database: 270.8.2/1741 - Release Date: 10/23/2008 7:54 AM
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
