I'm at the second set of resistance checks on the RF board (page 62). All look OK except U10 pin 8, the 8T line. It is over 1M ohm... Clearly that's > 500 ohms, but looks like I have an open somewhere. The 8R line is 2.5K.
I've eyeballed all the components on the 8T line / solder joints, etc. Q23, U10, & Q20 (none of the PA circuits are installed yet).
Normal? or trouble?
It's not worth much, but the K2 is functioning perfectly on 40M RX.
THANKS!
73, Bill N2BC
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
