I seem to be having a problem with the AGC control on my K2. With no
signal input, when I turn off the AGC the s-meter reads +40 and stays
there regardless of rf gain setting whereas the K2 manual indicates that
the s-meter should increase when turning the rf gain ccw. Also, I can
hear the 1uV signal from an XG2 with the AGC on but not with the AGC
off.
Has anyone experienced anything similar with the K2 AGC control not
working properly? I am wondering if this is an alignment issue of could
it be a bad or wrongly installed component on the circuit board?
Any advice greatly appreciated.
Jeff Fedison
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
