K2 Accessing TP3 with KDSP installed

[Byron Servies]

Hi there!

Last week I finished my now fully loaded K2 #7077 and thought I would
go through and re-do all of the various calibration steps.  It became
immediately clear that TP3 is now covered by the KDSP.

Is there a recommended way to perform these calibrations with the KDSP
installed?

73,  Byron N6NUL
K1 #2799
K2 #7077
--
- Northern California Contest Club
- CU in the 2012 Cal QSO Party 6-7 Oct 2012
- www.cqp.org
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

Byron,

No, you cannot get a probe to TP3 with the KDSP2 in place.
However, unless you have identified a problem that has occurred since
the last time you checked the PLL Reference range, it is not likely to
change.  I would say skip it - but if you find other PLL "strangeness",
then remove the KDSP2 to check it.

73,
Don W3FPR

On 4/21/2012 4:50 PM, Byron Servies wrote:

> Hi there!
>
> Last week I finished my now fully loaded K2 #7077 and thought I would
> go through and re-do all of the various calibration steps.  It became
> immediately clear that TP3 is now covered by the KDSP.
>
> Is there a recommended way to perform these calibrations with the KDSP
> installed?
>
> 73,  Byron N6NUL
> K1 #2799
> K2 #7077

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html