Hi,
My K2/100, s/n 4787, has experienced most of the model anomolies that have
been reported here on the reflector. My primary concern since day one has
been that the microphone audio input is simply not sufficient to drive the
K2 to full modulation on transmit. Changing the resistor on the SSB as was
suggested here on the reflector had only marginal results. Finally after
tiring of yelling into the microphone for two years I built the preamp
proposed by Don here on the reflector. No more yelling and that is great.
I built it into my home built digital interface. The mike plugs into the
interface and a switch choses between the mike and computer.
I've always been concerned about the S-meter accuracy and audio volume.
This week while trying to refine the S-meter adjustments it became very
apparent that their adjustment greatly affects audio volume. After very
carefully studying the responsitivity of the LO and Hi adjustments it
appears that finally S9 is in fact S9. However, the scale is not linear.
With S9 correct it is basically impossible to get a reading between S1 and
S4. The amazing thing is with S9 correct the audio volume is the equal to
about a third or more turn of the volume pot in the louder direction. The
S-meter calibration in the manual really needs help. So for those
constantly experiencing low audio double check your S-meter calibration.
Well, off my soapbox for now. Just wanted to share my experiences.
Jim, AB0UK
K2/100 s/n 4787
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
