Bill,
It sounds like the 40 meter frequency is incorrect - the K2 detects that
during a CAL PLL attempt.
Do you have the K60XV installed or the rework eliminator for the K60XV
option?
If so, enter the secondary menu and once again set D19 = "y" - your
master reset would have wiped out that setting.
You will have to re-do all your filter settings - hopefully you wrote
them down.
73,
Don W3FPR
Bill Strong wrote:
> I reset the EEPROM on my K2 SN#4454 because it stopped responding to COM PORT
> 1 commands from Ham Radio Deluxe. This cured this problem but now when I
> turn the radio dial the frequency readout changes but the frequency is not
> changing only on the 40 meter band. I am attempting to run CAL PLL but I
> keep getting the 232 error code. I have tried 7100.00 and several
> frequencies between 7000.00 and 7100.00. I have the frequency counter probe
> connected to TP1.
>
> I would appreciate any suggestions.
>
> Thanks
> Bill Strong
> WA5KPE
>
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.0.237 / Virus Database: 270.11.3/1971 - Release Date: 02/25/09 06:40:00
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
