K2 Filter and BFO Settings Question

[SABorns]

When setting the LSB BFO setting the called for frequency in the manual is  
4912.7. The lowest I can set mine is 4912.86.  All of the other settings on  
both CW and SSB can be set to the called for frequency. Do I have a  problem?
73,
Steve K8IDN
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Steve,

That is a normal result of an inadequate BFO range - go back to page 62 in
the manual and recheck the range.

BTW, my manual shows that the LSB BFO is to be set at 4913.7 rather than
your stated 4912.7.  Keep in mind that this is only an initial setting, you
will want to chage it after you install the KSB2 and even  after that, the
optimum setting is best observed by using Spectrogram or a similar audio
spectrum analyzer display.

73,
Don W3FPR

> -----Original Message-----
>
> When setting the LSB BFO setting the called for frequency in the
> manual is
> 4912.7. The lowest I can set mine is 4912.86.  All of the other
> settings on
> both CW and SSB can be set to the called for frequency. Do I have
> a  problem?
> 73,
> Steve K8IDN
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com