Nick Henwood wrote:
> I am sorting out my K2/100 which had an unhappy experience with a
* thunderstorm in 5x two weeks ago. Thanks for helpful comments.
*
> Almost there but.... I am doing the power calibration. I adjust R26
* to get the K2 and my power meter reading the same. All goes OK until
* I get to about 10W when I Get "Hi Curr" and the rig draws a lot more
* current e.g. from1.8A to 3.8A. I could stay with 10W for ever
1.8A seems a bit low for 10 watts.
* (probably enough to drive the linear) but this is not how it was.
This is a classic symptom of losing the output power monitoring diodes
on the 100 watt PA. I believe they are 1N5711's. There are many
examples of this in the list archives. The K2 isn't EMP hardened!
> Any ideas please?
[ Single line paragraphs have been wrapped and interparagraph
spacing added ]
--
David Woolley
"The Elecraft list is a forum for the discussion of topics related to
Elecraft products and more general topics related ham radio"
List Guidelines <
http://www.elecraft.com/elecraft_list_guidelines.htm>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
