Remove nothing until just before putting the front panel on the PC board -
then carefully remove the thin plastic film that protects the LCD. Scrape
up a corner with a fingernail - or if you must use a sharp instrument, take
care not to damage the harder plastic (glasslike) surface under the thin
plastic film.
73,
Don W3FPR
> -----Original Message-----
> From:
[hidden email]
> [mailto:
[hidden email]]On Behalf Of randt
> Sent: Saturday, April 09, 2005 11:15 PM
> To:
[hidden email]
> Subject: [Elecraft] K2 LCD (Protective Film On Backside)
>
>
> #4877 k2 in progress.
> My LCD has a light grey looking tape or film on the Back
> with no lines or yellowing.
> Page 27 in manual says(some LCDs (not all)may also have such
> film,with faintly visible yellow or gray
> diagonal lines.
> Do I leave this on or take it off?
> It is grey/white looking but no lines.
> Please help me in my wondering.
> Dont want to mess up now!
> Kinda believe this is part of LCD.
> kc4eyf
> Thanks
>
>
>
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft>
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
