Tomy,
What happens into a 50 ohm dummy load?
Do you see any HI CUR messages?
Has it always been this way? Or is this a new failure?
Is your power supply voltage dropping significantly during transmit?
If you power the K2 only through the 2.1mm coaxial power jack (remove
the APP connector from the KPA100), then what is the maximum power on
all bands? If it is above 10 watts (typically 12), then the base K2 is
OK. But if the power is much lower than that, you have a problem with
the base K2.
Make those checks and we will know better where to guide you.
73,
Don W3FPR
On 11/8/2010 2:10 PM, Tomy wrote:
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html