K2 MHz decimal Point

[Henry Ott]

Having fun learning to operate my recently built K2 #5654. It's a great
rig!

While setting up the scan functions, I notice that the MHz decimal
point flashes when in scan mode, as was stated in some of the
literature that I read. However, in normal mode (not scanning) there is
no MHz decimal point in the display.

Is there a way to have the MHz decimal point  in the display when not
scanning?

I read through the manual and could not find any reference to turning
the MHz decimal point on or off.  All my other rigs have both a MHz and
kHz decimal point displayed, and I would like to have the same on the
K2.

Any help would be greatly appreciated.

73,

Henry
WA2IRQ

Henry W. Ott
Henry Ott Consultants
www.hottconsultants.com
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com