Kevin, VK5KS has met exactly the same problem with the encoder, as I did.
Even flush,flush cutting of the leads did not solve the problem due to
a nearly imperceptibly slight bend of the control board.
The solution is to slide down an extremely thin sheet of plastic
(1 x1 inch) down between the front board and the control board, at the very place where
the encoder is sitting.
With a bend of 1/8 inch to the top, the sheet will not slide further down.
Simple Simon did it again.
73 OZ5RB
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
