K2 #2535 has no menus even though all other functions appear to work.
I did resistance and voltage checks on control board and found U6 pin
29 (/DASH) at .10v instead of the expected 5.0v. The 8v and 5v
regulators are good. The key jack is not shorted and measures 220ohms
to ground from P3 pin 17 when the dash circuit is closed. RP4 measures
82Kohms from pins 7 to 8. When powered up, RP4 pin 7 measures 5v, but
pin 8 is at .10v. Pin 8 voltage does not change when U6 is removed
from socket. Any hints would be appreciated on where to go from here.
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
