[K2] Noise Blanker problem

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

[K2] Noise Blanker problem

bdenley
I am still getting the Not Installed message with the KNB2.  I have built
and re-built the board, rewinding L1 and L2 twice and resoldering all the
joints again.  Resistance  between pins 1 and 6 is way up in the megohm
range.  What should it be?    Any suggestions would be welcome.
Brian
KB1VBF
http://home.comcast.net/~b.denley/index.html 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: [K2] Noise Blanker problem

Don Wilhelm-4
  Brian,

A Not Installed indication for any K2 option indicates a problem with
either that option's microprocessor or a continuity on the AUXBUS
signal.  Check the soldering, especially at the KNB2 firmware chip pin
1, as well as the other pins of the firmware chip.

The other possibilities are the 4 MHz resonator or the firmware chip itself.

73,
Don W3FPR

On 1/29/2011 9:12 PM, Brian Denley wrote:
> I am still getting the Not Installed message with the KNB2.  I have built
> and re-built the board, rewinding L1 and L2 twice and resoldering all the
> joints again.  Resistance  between pins 1 and 6 is way up in the megohm
> range.  What should it be?    Any suggestions would be welcome.
> Brian
> KB1VBF
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html