Issac,
Be certain that auto-detect is turned on. If it is off, behavior will
be exactly as you describe.
Enter the menu for INP, press EDIT and then tap the DISPLAY button to
toggle ADET - if you tap DISPLAY once and see ADET ON, you will know
that it had been set to OFF, Multiple taps of DISPLAY will toggle ADET
on and off.
73,
Don W3FPR
TL_Netvision wrote:
>> Hello all
>> I have my paddle & a computer interface for keying CW connected as per
>> the manual (incl 2 diodes, cathodes at the key-line, anodes at dit &
>> dah terminals).
>> The interface is a simple switch (opto coupler 4N37) driven by DTR
>> (RTS is in use by KIO2).
>>
>> The problem is that I can't get proper keying from the computer unless
>> the K2 is put in "Inp=Hand" mode.
>> Doing that the paddle is useless(only one paddle is active).
>> Setting back to padln - the paddle works great but than keying from
>> the computer is as if pressing both dit & dah paddles. (Makes perfect
>> sense to me because both diodes are pulled low).
>>
>> I think the manual says that having an arrangement such as mine is
>> possible because of some auto detecting done by the firmware, but
>> that's not working here.
>> Firmware is 2.04p, IO is 1.09.
>>
>> Any ideas?
>> Thanks in advance, Isaac, 4Z4TL, k2 #1574.
>>
>>
[hidden email] http://www.iarc.org/~4z4tl
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
