K2 Question

[Christophe F8ACF-56]

hello all,

control board on K2, there "P7" he must put the rider in a unique position to test or not to wear?

there is nothing to indicate on this jumper, so I would ask.

during assembly

K2 # 7369
 
73 , Christophe F8ACF-56
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

Christophe,
That header is to select the input to the internal K2 voltmeter.  If you
are using that sincle wire probe that the manual instructs you to build,
you will put the jumper on the two pins marked "EXT", but normally you
will place it on the pins marked "INT"

Note, if you have th ejumper on EXT and do not connect a voltage to the
probe, you will see an occasional "LO BAT" display flashed.

73,
Don W3FPR

On 10/22/2012 6:26 AM, Christophe F8ACF-56 wrote:

> hello all,
>
> control board on K2, there "P7" he must put the rider in a unique position to test or not to wear?
>
> there is nothing to indicate on this jumper, so I would ask.
>
> during assembly
>
> K2 # 7369
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Christophe F8ACF-56]

hello list,

Thank you again now it is more clear to me.

 
73 , Christophe F8ACF-56


________________________________
 De : Don Wilhelm <[hidden email]>
À : Christophe F8ACF-56 <[hidden email]>
Cc : "[hidden email]" <[hidden email]>
Envoyé le : Lundi 22 octobre 2012 15h33
Objet : Re: [Elecraft] K2  Question
 
Christophe,
That header is to select the input to the internal K2 voltmeter.  If you
are using that sincle wire probe that the manual instructs you to build,
you will put the jumper on the two pins marked "EXT", but normally you
will place it on the pins marked "INT"

Note, if you have th ejumper on EXT and do not connect a voltage to the
probe, you will see an occasional "LO BAT" display flashed.

73,
Don W3FPR

On 10/22/2012 6:26 AM, Christophe F8ACF-56 wrote:

> hello all,
>
> control board on K2, there "P7" he must put the rider in a unique position to test or not to wear?
>
> there is nothing to indicate on this jumper, so I would ask.
>
> during assembly
>
> K2 # 7369
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html