Tom,
There is nothing associated with either of those options that would
change the dial calibration - so if it really changed during the
installation of those options, it had to be something that was
inadvertently touched.
Did you do a Master Reset? If so, you will find all your BFO (filter)
settings set back to the defaults - you did record those settings before
doing the reset, did you not?
If you were not aware, there is a complete procedure for doing the K2
Dial Calibration on my website www.w3fpr.com.
73,
Don W3FPR
On 11/6/2013 12:16 PM, Tom Field wrote:
> As per my previous note, I just finished the KPA 100 and KIO2 Mods for my
> K2. Thanks Don for the suggestions on USB to serial.
>
> While listening around the bands, I find that my tuning is off, which
> wasn't the case before the mods. WWV is off by several Hz, and when I tune
> in CW, I find it loudest and the tone is nowhere near my sidetone, making
> the SPOT useless. Frequensee on my phone has the tuned CW signal at about
> 1200 hz and my sidetone is 600 hz. Before going through the complete
> retuning process, my question is there something I should check regarding
> the recent mods?
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
