K2 Removal of DSP module

[George]

If I were to remove the DSP module, what would I need to do to return the  
K2 to operate without it? Perhaps a couple jumpers?   Tnx  Geo/W2BPI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

  Yes, two wire jumpers are needed.  One between CB J1 pin 1 and J2 pin
1 - the other between J1 pin 2 and J2 pin 2.  The original jumpers were
soldered, but component leads bent ans stuck into the J1 and J2 headers
will work quite nicely.

73,
Don W3FPR

On 2/10/2011 4:42 PM, [hidden email] wrote:
> If I were to remove the DSP module, what would I need to do to return the
> K2 to operate without it? Perhaps a couple jumpers?   Tnx  Geo/W2BPI
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html