Euan,
Wires 1 and 2 are on the same winding, and 3 and 4 are the other
winding, and it is symmetrical about the axis that tuns through the
center of the core. In other words, if you flip it over in that manner,
it looks the same - no need to change it.
Now if you had turned it around the other way and soldered the 1-2
winding in the 3-4 holes, that would make a huge difference, and would
need to be corrected.
73,
Don W3FPR
Euan wrote:
> I've installed T4 "upside down", that is wire 3 goes to the 4 hole, and wire
> 4 goes to the 3 hole, with the same mis-ordering for wires 1 and 2. Is this
> important? I'm running low on hookup wire so hope I don't have to re-do
> this.
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
