|
I am looking to upgrade a friend's older K2, sn 280. What mods are
recommended as necessary and what would be in the nice to have category. This is a plain vanilla K2, CW only, QRP, no 160, 60 meters, etc. -- Mike Herr WA6ARA DM-15dp Home of The QRP Ranch No trees were killed in the sending of this message, however, a large number of electrons were terribly inconvenienced. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] |
|
Mike,
Download the A to B instructions from Elecraft, and look at the first page. It will have a list of other associated upgrade kits. If you think some of the upgrades have already been installed, download the instructions for each and do a physical examination of the K2 to see if any of those have been previously installed. In addition to those upgrades, look at the designations on the IF crystals. If they do not end in "-S", those crystals should be updated as well for better filter performance. If the KSB2 is installed, look at those crystals as well. If you need to update the KSB2 crystals as well as the main RF board IF crystals, order the matched set of 14 crystals - if only the RF board needs updated, order the set of 7 crystals. If you are replacing the crystals on the KSB2 board, consider widening the OP1 filter width to 2.4kHz instead of the original 2.1kHz. Of course, you should update the firmware. In addition, the AF Gain control is likely to be scratchy, so order a new AF Gain pot and install the Alternate AF Gain Control Wiring mod. I would advocate doing all the upgrades at once while you have it open. The cost of each of the mod kits is quite reasonable ($10 to $20 range), but the firmware is priced at $54 and is the most expensive part of the upgrade. If there is no KSB2 board, then the 2nd Xtal Flattening Mod can be skipped, but I would install all the others, including the crystal change. 73, Don W3FPR On 9/2/2015 5:28 PM, Mike Herr wrote: > I am looking to upgrade a friend's older K2, sn 280. What mods are > recommended as necessary and what would be in the nice to have category. > This is a plain vanilla K2, CW only, QRP, no 160, 60 meters, etc. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] |
| Free forum by Nabble | Edit this page |
