Bob,
Have you first checked the PLL range? With the probe in TP3 (you may
have to remove the KDSP2 or KAFT2), and menu in CAL FCTR - what is the
frequency when you tap the BAND+ button? What frequency when you tap
the BAND- button?
If you have a good PLL range, then the frequency should decrement during
CAL PLL. You say it does not, and I believe that, but start with the
PLL range frequencies and then we can hone in on the problem spot.
73,
Don W3FPR
rrkrr wrote:
> K2 #3766, a kit I bought a few years ago and let sit on the shelf for
> a while - I'm finally threatening to finish it.
>
> All has gone well up to the "VFO Linearization" step in Alignment
> where the CAL PLL menu item is supposed to be run. I've followed the
> instructions to the letter, but when I go through the menu, select CAL
> PLL and hold the "EDIT" key to start the linearization sequence....
> nothing. A 12099 kHz frequency is displayed, but does not change.
> There are no "d"s displayed to indicate stored data points. Nothing
> happens.
> MCM firmware is 2.03. IOC firmware is 1.07
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
