K2 XV50 Incorrect Frequency Display Problem

[Ron Hahn (EI2JP)-2]

Colleagues,

I just finished assembling an XV50 to go with my K2 SN4922.. I'm using
it with the K60XV interface.

After doing all the config of both the K2 and the XV50 as recommended in
the manuals, I switched from 10m to 6m and get a display of 36101.60, a
far cry from six metres!!  Have I configured something incorrectly or do
I have some other problem that needs troubleshooting?

Thanks for the help,

Ron EI2JP

--
This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-4]

Ron,

You apparently missed the part in the manual that tells you to do a
direct frequency entry if the frequency display comes up incorrect.

73,
Don W3FPR

Ron Hahn (EI2JP) wrote:

> Colleagues,
>
> I just finished assembling an XV50 to go with my K2 SN4922.. I'm using
> it with the K60XV interface.
>
> After doing all the config of both the K2 and the XV50 as recommended
> in the manuals, I switched from 10m to 6m and get a display of
> 36101.60, a far cry from six metres!!  Have I configured something
> incorrectly or do I have some other problem that needs troubleshooting?
>
> Thanks for the help,
>
> Ron EI2JP
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com