I am about done with part 1 of the assembly of the KPA100 option. I opened
the K2 and removed pin 4 from P4 on the control board per the instructions.
Rather than connect the partially assembled KPA100 to the K2, I powered up
the K2 first. Now the K2 doesn't initialize.
Here are the symptoms:
1. I power up the K2. There is no visual indication the unit is powered up.
2. I turn the K2 off and power it on again. This time the LCD display shows
ELECrAFt and stops there. There are LEDs lit on the S meter.
I've double checked and am sure I cut the right pin. It is the header that
connects to the KIO2 unit I think. The control board has been reseated and
number of times to be sure.
I didn't build the K2 and bought it used recently. So I don't know my way
around the rig. I was hoping to finish the KPA100 option this weekend, but
now I need to get the K2 working again.
73,
Steve N6VL
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
